Before gluing, the surface of the wall must be prepared. Old wallpapers are removed, whitewashing is thoroughly washed off. The walls are plastered, putty, if necessary, they are covered with a primer.
The edge is cut off for the wallpaper if it is. When planning the wallpaper sticker, the edge is cut off on one side. It should be determined which side will be cut off, it depends on the direction of work: if from left to right, then the left edge is cut, the right direction is in the opposite direction.
It is advisable to carry out vertical markings on the wall with a simple plumb line. It is better to start it with the location of the second sheet 3-5 cm moving to another wall.
The adhesive mass is prepared in advance so that it has time for swelling. Depending on the type of wallpaper, it can be applied simultaneously on the wall and wallpaper, as well as only one surface. Pieces of wallpaper are spread on paper or simply on the floor down with the front side and are evenly smeared with glue. The canvas of dense wallpapers must be given time for impregnation.
The wallpaper sheet is applied to the wall, respectively, the marking and pressed with smooth movements from top to bottom, and then from the center to the edges with a roller or a clean rag. Excess glue are removed immediately.
In the room whose walls are pasted with wallpaper there should not be drafts. Also, you should not try to speed up the drying process using heaters.
Usually, if people make repairs in the room, at the same time they replace interior doors. You can also order doors in bulk in Ufa. Doors are made only from high -quality materials and in compliance with all technologies.
