The premium collection includes the Baum Oak Silver Parquet board. The boards are the planks large enough in width, the upper layer of which is made of an oak massif (the thickness of the array reaches four millimeters). This is a real parquet on which a large texture of natural raw materials is perfectly visible. The design is stable due to the whole outer layer. Baum boards look the same with wide massive premium boards, but they are much easier to install and they are not affected by clicking.
The inner layer is represented by the wood. It is more dense, homogeneous, and therefore stable. This exceeds the characteristics of conifers that are used to produce parquet in many manufacturers. As the lower layer, the whole veneer of the gvee is used, which protects the base from excessive humidity. It is permissible that several dicks of the lower layer grow together.
Baum Premium oak silver is made of wood pre -treated under a high temperature. Oak is smoked, and this affects the shade of wood, it becomes more chocolate throughout the depths. This method of processing also affects the climatic stability of products, they hardly feel the difference in temperature.
The surface of the board is braided, that is, soft fibers are cleaned from the surface. After breastfeeding, the annual rings of the tree are very clearly visible and it is pleasant to touch the product. The board after such processing is more practical, because the scratched areas and irregularities are hidden. Washing such a floor is not difficult, since all the boards are covered with protective varnish.
Parquet has a gray oak along the entire length. These are small bevels with the edge that contribute to the visual selection of each bar. If the chamfer is large, then it looks noble, as it emphasizes that the material was used natural, and also allows you to choose the right direction for the installation of boards. In addition to aesthetic perception, it helps to hide small cracks. Slits may appear if you do not comply with the norms of use of the product – applicable to the Russian climate (sharp temperature changes occur).
Parquet is covered with seven layers of the UF-laca. By its properties, the varnish rejects ultraviolet rays and forms additional protection on the surface. The tests conducted that when processing wood products with this varnish, they will last more than thirty years.
Each Parquet Parquet bar contains the Leimlose MontageSystem Unilin BSKLEVA. The boards are connected reliably. The castle received a large number of positive reviews from specialists in laying parquet. It has high strength and it can be used many times. You can dismantle the flooring if you are going to move, and re -lay it in new walls. No need to use additional adhesives, nails, sealant.
Laying is carried out on the base, pre -prepared. It should be dry, durable. The basis can be a screed, a bulk floor, moisture -resistant plywood, GVL. The surface of the base of the base in height is not more than two millimeters per two square meters is allowed. First lay a cork substrate, the thickness of which is not more than 2 mm. Or a similar material. If installation is made on a screed or a bulk floor, it is better to lay polyethylene (two hundred microns) before laying the substrate).
Depending on the volume, this product can be bought at a discount, the size of which can be clarified by the manager
* Parquet board is sold packages. The final number of parquet is calculated based on the necessary number of packages.
